Cobalt-digital COMPASS 9363 Multi-Format Reference Generator Manual de usuario descargar pdf (Pagina 19)

9363-OM (V1.2) 9363 PRODUCT MANUAL 2-1

Chapter 2

Chapter 2 Installation and Setup

Overview

This chapter contains the following information:

• Setting Card Jumpers (p. 2-1)

• Installing the 9363 Into a Frame Slot (p. 2-4)

• Installing a Rear I/O Module (p. 2-2)

• Setting Up 9363 Network Remote Control (p. 2-5)

Setting Card Jumpers

The AUX I/O connector on the 9363 Rear I/O Module is a multi-purpose BNC

port that can be set as either a

Local (External) BNC reference source input,

or an AES/Word Clock (

AES/WC OUT) output depending on the jumper

positions.

(See Figure 2-1.) Jumpers

JP1 and JP2 set the AUX I/O BNC connector

function as described below. Depending on function desired, set these jumpers

before installing the card in a frame.

• JP1 (EXT TERM) – Sets card aux BNC connector to use card internal

75-ohm termination. This position is the default position and is recom-

mended unless the connection is to be looped within a 75-ohm externally

terminated chain.

• JP2 (REF IN / AES OUT) – Sets card aux BNC connector to either serve as

an extra (Local/External) reference input (factory default position), or serve

as an AES/word clock output (AES/WC OUT).

Figure 2-1 9363 Termination and AUX I/O BNC Jumpers

Rear of Card

•••

JP1 (Ext Ref)

OFF ON

•••

JP2

REF AES

IN OUT

Note: Default factory settings shown.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Sin comentarios

Cobalt-digital COMPASS 9363 Multi-Format Reference Generator Manual de usuario Pagina 19